Home> Industry Information> Slitter operation considerations

Slitter operation considerations

August 13, 2019

1 ) Static electricity will cause the Slitting machine control system to malfunction or be damaged. Before starting the machine, please open the static eliminator. (Make sure the power switch is turned on)

2 ) Adjust the supply pressure to ( 0.5-0.6 ) Mpa

3 ) Move the parent roll to the unwinding section and choose to use 3 // or 6 // conehead. Press the bobbin diameter of the parent roll and press the slitting machine up or down to adjust the feeding frame to the proper height and visually check the width of the mother roll. Cone cylinder stroke travel rack to fit the width of the film roll cone top clutch knob clamping film roll.

4 ) Press the up or down button again to adjust to the proper height.

5 ) follow the feed diagram for the film, and hand traction to the reeling shaft position, the use of photoelectric switch positioning.

6 ) Move the electric eye to the proper position and tighten the handwheel. (Adjusted to be able to edge detection line or line detection position) and press the automatic correction. (You can fine-tune the photoelectric eye)

7 ) Use the boom on the unloading operation box to release the take-up reel bracket and release the take-up reel. The amount and size of the paper used in the collection of spools. Close the take-up reel holder using the boom lock on the unloader box to lock the take-up reel auxiliary contact press roller. (Depending on the width of the sub-select a suitable auxiliary contact pressure roller.

8 ) Install the blade, select the slitting machine mode, adjust the cutter position, the use of infrared paper positioning system, modify the position of the paper core, the cut film affixed to the core.

9 ) Confirm that the length encoder is close to the take-off roller.

10 ) Confirm the start-up operation has been completed, set the parameters of film thickness, winding tension, length of slitter and other parameters on the touch screen, and use the fan switch to turn on the fan to import the waste edge into the air duct.

11 ) Determine the speed setting indication is 0 , press the start button, confirm that no accidental use of the speed switch button to light, and then use the acceleration knob to speed up the boot operation.

12 ) Press the stop button, the take-up reel and drive roller begin to decelerate and decelerate to stop. (Winding and driving automatically decelerate and stop when the winding diameter and length are about to reach the set value)

13 ) very stop only in the very moment can be used!

The above is the Slitter operation considerations we have listed for you. You can submit the following form to obtain more industry information we provide for you.

You can visit our website or contact us, and we will provide the latest consultation and solutions

Share to:

Send Inquiry

Home> Industry Information> Slitter operation considerations

Copyright © 2024 Sunny Machinery Factory All rights reserved. Privacy Policy

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Send