Is the job flow of the slitter clear? The operation of the slitter's machinery and equipment is inconceivable because some people underestimate their work and are not serious when they work. If accidentally caught in the machine, an accident occurs. Therefore, every technical worker entering the factory must understand Security matters are very strict in this regard. Here we introduce the safety operation procedures and precautions for the cutting machine.
Slitter safety process:
1, check the machine equipment is normal and the roller scrub clean:
2, in the corresponding position and install the necessary width and width of the mold and the blade, the mold and the blade must not have oil, dust, rust and other blades must be sharp
3, the paper tube used for rewinding is installed on the reel
4. The slitting diaphragm shall be fixed on the diaphragm frame behind the machine. The diaphragm must be fixed, and it shall not move left and right or shake up and down.
5. Pull the diaphragm apart and align it with the small diaphragm of the required size and fix it on the paper sleeve. Need to cut the diaphragm shaft, the mold and the blade shaft, the reel must be flush.
6. Turn on the power switch, turn on the machine, try cutting, and check whether it meets the required size requirements.
7. After confirming the pass, adjust the appropriate speed slitting diaphragm.
8. After the entire roll slitting is completed, turn off the power switch of the machine, attach a sticker on the surface of the small roll diaphragm, and label the model number.
9. After slitting the diaphragm and passing the QA inspection, use a plastic bag or a carton to keep it in a dustproof condition or transfer it to the next process.
Safety precautions for slitters:
1: Inspect the work clothes according to company safety regulations.
2: Before starting the machine, it is necessary to check whether there is any debris in each rotating part and whether there is lubricating oil.
3: If there is any abnormality in the running process, it must be shut down for inspection. It is forbidden to handle it during operation.
4: Forbidden to operate the machine for maintenance. If it needs maintenance, it must be stopped before maintenance.
5: Irrelevant personnel are forbidden to touch the switch device.
